|
+ + + + + + + + + + + + + + + + + + + + + + + + + + + + + + + +
2019-08-20 Release Notice DEWEConfig v3.6.1
Configuration tool for DEWETRON DAQP/HSI amplifiers.
*Version: 3.6.1
* Components:
** DEWEConfig 3.6.1
** LabVIEW Runtime engine 2016 32 bit
** NI-VISA Runtime 17.5
* Requirements:
** in case of RS232 from PC COM Port: Windows 10 64-Bit or Windows 7 64/32-Bit
** in case of RS485 from DEWETRON DAQ: DEWETRON DAQ driver ≥ 2.1.0.0 and Windows 7 64/32-Bit
** in case of RS485 from DEWETRON DSA: DEWETRON DSA driver ≥ 4.1.0.0 and Windows 7 64/32-Bit
* Installation Procedure:
** Run installer with default settings
* Supported Hardware
** DAQP-ACC-A, DAQP-CHARGE-B, DAQP-DMM, DAQP-HV, DAQP-LA, DAQP-LA-SC, DAQP-LV, DAQP-MULTI, DAQP-V, DAQP-V-A, DAQP-V-B, DAQP-STG, DAQP-THERM, DAQP-CFB2, DAQP-CHARGE-A, DAQP-FREQ-A
** HSI-HV, HSI-LV, HSI-STG
** PAD-TH8-P + PAD-CB-xxx, PAD-V8-P, EPAD-TH8-x, EPAD-V8, EPAD-RTD8
** DAQP-LA2-B-S6 (will be displayed as DAQP-LA-SC)
* Not Supported Hardware
** DAQP-FREQ, DAQP-BRIDGE-A, DAQP-BRIDGE-B, DAQP-ACC
** legacy PAD modules (PAD-TH8, PAD-V8 with GREEN LED), PAD-DO7, PAD-DI8, PAD-RTD3
* New Features and most important bugfixes:
** Bugfix for input range unit calculation and scaling factor
* Known Limitations:
** Custom range support for DAQP-STG and HSI-ST: only symmetric custom ranges (no offset)
** In case of RS485 from DEWETRON DSA/DAQ: no support of Windows 10 64 Bit
** No support of customized DAQP-LA modules other than V100 and V110
** No support of custom ranges (except DAQP-THERM, DAQP-Multi and DAQP-CHARGE-B)
** No auto setup of amplifiers according TEDS settings from MSI and TEDS enabled sensors
** DAQP-LA2-B-S6 will be displayed as DAQP-LA-SC (pinout image incorrect)
** Multilanguage support covers most elements, but not all. Tip strips and help yet in English only. |
.jpg)